FlexiO steering | Eastron Meter
Explanation
FlexiO needs qualified measurement of the current streams in order to steer your installation for grid balancing.
A HomeWizard Eastron meter (commonly installed in the fuse box) might be added to your installation for either reading out the grid current stream or retrofit PV panels current stream (existing older installation of solar panels).
This error message indicates that a HomeWizard Eastron meter has been configured for FlexiO however the meter is not found on the network or not responding.
An Eastron Meter error implies that FlexiO isn’t running or runs on a degraded level.
Your installation might or should be self-steering capable and thus fall-back to the local steering of your inverter.
Required action
Execute following steps
Make sure you didn’t change anything on the local network recently: this includes new modem and/or new internet provider, Wi-Fi changes such as new SSID (wireless network) name or an update of the Wi-Fi password.
Check the FlexiObox:
The LED on top should be continuous green
The network cable should be plugged in on the other side of the green LED - make sure the cable is well connected
LED’s should be on or blinking close to the FlexiObox network connector (at the bottom side)
Unplug the power of your FlexiObox (small USB-C connector on the side, comparable with your phone battery charger connector), wait 5 seconds and plug in again: after approximately 1 minute the LED on top should be back continuous green
Not solved?
If this error persists, contact your installer.